NEC PX1004UL-WH - Page 44

27
2. Projecting an Image (Basic Operation)
Applicable lens unit: NP31ZL
1. Focusontheprojectedimagearoundtheopticalaxis.(Poweredfocus)
 PresstheFOCUS+/−buttonuntilyoucanobtainthebestfocus.
 (TheFOCUSadjustmentbarwillbedisplayedon.)
 Thedrawingbelowshowsanexamplewhentheprojectedimageisshiftedupward.Inthiscasetheopticalaxis
isatthebottomedgeoftheprojectedimage.
Adjusting with buttons on the cabinet
PresstheFOCUS+/−BUTTONonthecontrolpanel
Adjusting with the remote control
PresstheVOL/FOCUSbuttonholdingtheCTLbutton
• ◀or▶buttonsonthecabinetortheremotecontrolarealsoavailabletoadjustFOCUSwhiletheFOCUS
adjustmentbarisdisplayedon.
Opticalaxis
* Whenthelensisatthecenterposition,theopticalaxisisatthecenteroftheimage.Inthiscase,adjustthe
focusatthecenteroftheprojectedimage.