NEC PX1004UL-WH - Page 121

104
5. Using On-Screen Menu
Tocalluptheadjustedvaluesfrom[LENSMEMORY]:
1. Fromthemenu,select[ADJUST]→[LENSMEMORY]→[MOVE]andpresstheENTERbutton.
 Theconrmationscreenwillbedisplayed.
2. Press the ◀buttontoselectand[YES]andpresstheENTERbutton.
 Duringprojection,iftheadjustedvaluesforaninputsignalhavebeensaved,thelenswillshift.Ifnot,thelenswill
shiftaccordingtotheadjustedvaluesstoredintheselected[REF.LENSMEMORY][PROFILE]number.
Toautomaticallyapplytheadjustedvaluesatthetimeofsourceselection:
1. Fromthemenu,select[SETUP]→[INSTALLATION(2)]→[REF.LENSMEMORY]→[LOADBYSIGNAL]and
press the ENTER button.
2. Press the ▼buttontoselectand[ON]andpresstheENTERbutton.
 Thiswillmovethelensautomaticallytothepositionatthetimeofsourceselectionaccordingtotheadjusted
values.
NOTE:
• TheLensMemoryfunctionmaynotproduceacompletelyalignedimage(duetotolerancesinthelenses)usingtheadjusted
valuesstoredintheprojector.AftercallingupandapplyingtheadjustedvaluesfromtheLensMemoryfunction,nelyadjustthe
lensshift,zoomandfocustoproducethebestpossibleimage.