NEC PX1004UL-WH - Page 46

29
2. Projecting an Image (Basic Operation)
TIP:Toobtainthebestfocus,performthefollowing(forpermanentinstallation)
Preparation:Warmuptheprojectorforonehour.
1.PresstheFOCUS+/−buttonstochecktheadjustablefocusrange.Forcheckingitbytheremotecontrol,pressandholdtheCTL
buttonandpressVOL./FOCUS+/−button.Iftheprojectorinuseisnotwithintheadjustablefocusrange,movetheprojectorback
and forth.
2.Selectthe[TESTPATTERN]fromthemenuanddisplaythetestpattern.(→ page 88)
• Fordisplayingthetestpatternbytheremotecontrol,pressTESTbutton.
3.KeeppressingtheFOCUS−buttonuntilthegridofthetextpatternbecomesinvisible.
• TheFOCUSadjustmentbardisplayingpositioncanbeshiftedorbeturnedofftemporarily.(→ page 36, 37)
4.KeeppressingtheFOCUS+buttonuntilyouobtainthebestfocus.
 Forobtainingthebestfocusbytheremotecontrol,presstheVOL./FOCUS+buttonwhileholdingtopresstheCTLbutton.
 Ifyouadjustbeyondthebestfocalpoint,gobacktostep3andrepeattheprocedures.
5. Turn the edge focus ring clockwise or counterclockwise to adjust the focus at the edges of the projected image.
Applicablelensunit:NP39ML
1. Focusontheprojectedimagearoundtheopticalaxis.(Poweredfocus)
 Theopticalaxisisatthebottomoftheimage.
 PresstheFOCUS+/−buttonuntilyoucanobtainthebestFOCUSaroundtheopticalaxis.(TheFOCUSadjust-
mentbarwillbedisplayedon.)
 Inanotherway,presstheVOL/FOCUS+/−buttonwhileholdingtopresstheCTLbuttonontheremotecontrol.
Opticalaxis
• ◀ or ▶buttonsonthecabinetortheremotecontrolarealsoavailabletoadjustFOCUSwhiletheFOCUSadjust-
ment bar is displayed on.