NEC Series E - Work Mode During a Call

TO SET/RESET
BREAK MODE
WHILE ENGAGED IN AN ACD CALL
♦ Press BREAK
key, lamp lights
steadily.
Then changes to:
♦ Position in the Break mode upon completion
of the conversation, will be taken out of queue
and no ACD calls will be routed to the position.
3
(Time display)
WATS
(Time display)
BREAK PENDING
FROM READY STATUS USING A NORMAL
BREAK TYPE
♦ Press BREAK key,
lamp lights steadily.
TO RESET
♦ Upon completion
of Break mode,
press BREAK key.
Lamp lights steadily.
Then changes to:
♦ Break mode is canceled
and the LCD display
indicates time spent
on break in minutes
and seconds.
NOTE: Break mode can be set if any call is on hold.
Break Mode may be set/reset when NON-ACD LINE
is actively engaged in a call.
(Time display)
READY
15:00BREAK OVER
(Time display)
ON BREAK
(Time display)
15