NEC SL1100 - Page 233

Dial Action Table on page 2-60
Defines the dialing options for the Call Routing Mailbox chosen by the active Answer Table.
System Administrator on page 2-229
The System Administrator can record the Instruction Menu for a Call Routing Mailbox. See Operation
below.
Programming
1. Set up the Call Routing Mailbox.
Program
Number
Program Name Description
47-07-02 Routing Mailbox Type
(Mailbox Type)
Enter 1 to assign the mailbox as a Call Routing Mailbox.
By default, Routing Mailboxes 1-8 are Call Routing Mailboxes and
9-32 are Announcement Mailboxes.
2. Record an Instruction Menu for the Call Routing Mailbox:
See Operation on page 2-216.
The default Instruction Menu is: “If you are calling from a touch tone phone...”
3. Assign Dial Action Table to provide dialing options for this Call routing Mailbox:
Program
Number
Program Name Description
47-08-01 Dial Action Table Enter the Dial Action Table (e.g., 1) that provides the dialing op-
tions.
By default, all Call Routing Mailboxes use Dial Action Table 1.
4. Change the amount of time Automated Attendant callers have to dial options:
See Automated Attendant on page 2-31 for more.
Program
Number
Program Name Description
47-08-03 Time Limit for Dialing Com-
mands
(Dialing Timeout)
Enter the new timeout duration (0-99 seconds).
By default, Automated Attendant callers have 5 seconds to dial
commands.
When the timeout duration is exceeded or is not programmed, the
following actions occur:
• When a Timeout action is programmed, the call routes to that
destination.
• When a Timeout action is not programmed, the Instruction Menu
repeats 3 times and then InMail hangs up.
ISSUE 3.5 SL1100
InMail Feature Manual 2-215
R