Programming
1. Assign the TRF action to a key on the active Dial Action Table.
Program
Number
Program Name Description
47-13-01 Dial Action Tables:
TRF Action - Screened Trans-
fer (1) (TRF)
Normally, the corresponding Number option should be XXX. Note
the key you choose for this action is the first digit of the called ex-
tension.
• For example, to allow callers to place Screened Transfers to ex-
tensions 101 ~ 212 (V3.5 Changed), for key 3 enter TRF for the
Action and XXX for the corresponding Number.
To have Screened Transfer call a specific extension, the corre-
sponding Number option should be that extension number. The call-
er then dials that single digit to reach the extension.
• For example, to have callers dial 8 to reach extension 303, for
key 8 enter TRF for the Action and 303 for the corresponding
Number.
By default, key 1 Action is UTRF and Number is XXX. This means
that Automated Attendant callers can place Unscreened Transfers
to extensions 101 ~ 212 (V3.5 Changed).
2. Set how long a Screened Transfer rings an unanswered extension before recalling to the
Automated Attendant.
Program
Number
Program Name Description
47-08-02 Screened Transfer Timeout
(Scrn Trf Timeout)
Set how long a Screened Transfer (TRF) from the Automated At-
tendant rings (0 ~ 255 seconds) an unanswered extension before
recalling.
Be sure that the 24-02-04 Transfer Recall Time is longer than the
setting of this option. If the Transfer Recall is shorter, Screened
Transfers recalls the same as Unscreened Transfers.
By default, this option is 15 seconds.
Operation
Not applicable.
ISSUE 3.5 SL1100
InMail Feature Manual 2-219
S
To Next Page
Loading...
