Chapter 7 Disk Array Configuration Setting
IV-79
(7) Checking for the parameters for batch binding the logical disks
Clicking the [Next] button on the “Setting Detail Parameter for LD Binding” screen displays the “Confirmation
for LD Batch Binding Parameter” screen. Check for the parameters specified for batch binding the logical disks,
then click the [Next] button to start binding the pool(s) and the logical disks.
Figure 7-67 Checking for the Parameters of Batch Binding the Logical Disks
(A) Parameters for the pool(s)
Pool Type: Type of the pool(s)
RAID Type: RAID type of the pool(s)
Pool Capacity: Capacity per pool
Number of Pools: Number of pools to bind
Total Pool Capacity: Total capacity of the pool(s) to bind
Total Unused Pool Capacity: Capacity which is not used for binding the logical disks in the pool to bind
To Next Page
Loading...
