uPASS Target | installation guide
20/
3.2.4 USB
The uPASS Target reader features a mini USB interface for service, installation and firmware upgrade purposes. The
USB interface creates a virtual COM port that can be used the same way as a normal (serial) COM port.
The USB interface may be used to communicate with:
• UHF processor (SW1-1 OFF)
• TRANSIT compatible processor (SW1-1 ON)
Figure 15: USB (mini) interface with SW1
USB driver installation
Make sure your computer is connected with internet. Connect the uPASS Target reader to your computer via the USB
cable. The USB drivers may be installed automatically. In case you need to install the USB drivers manually, please go
to the website www.ftdichip.com/Drivers/VCP.htm
and download the VCP (Virtual Com Port) drivers. After successful
installation of the USB drivers the reader will appear in the Windows device manager in "Ports (COM & LPT)" section.
To Next Page
Loading...
