uPASS Target | installation guide
26/
6 Reader configuration
The uPASS Target reader settings can be configured easily using the UHFTOOL software. The UHFTOOL requires a
Microsoft Windows installation to run. Software developers can find the communication protocol description in the
firmware guide
6.1 UHFTOOL software
Figure 22: UHFTOOL software
6.2 Connecting
To connect to the uPASS reader click File -> Connect, press F2 or click on the connect button. This opens the connect
dialog. Select the following communication parameters and click OK to establish the connection.
COM-port
Baud rate
Communication protocol (STANDARD or OSDP)
Device address (only for OSDP)
Figure 23: Connect dialog
To Next Page
Loading...
