uPASS Target | installation guide
8/
2 Installation
The uPASS Target can be mounted to any surface with the wall mounting bracket and Pole Mounting Set (see appendix
E for part numbers). The uPASS Target can be “aimed” at the desired detection area with the mounting brackets.
2.1 Safety instructions
The following safety precautions shall be observed during normal use, service and repair.
• The uPASS Target shall only be installed and serviced by qualified service personnel.
• Disconnect the power supply before (dis)connecting any wires, uPASS Target is NOT hot-swappable, so when
making or changing connections, power must be switched OFF.
• To be sure of safety, do not modify or add anything to the uPASS Target other than mentioned in this installation
guide or indicated by Nedap N.V.
2.2 Reader dimensions
The dimensions of the uPASS Target reader can be seen in Figure 1.
Figure 1: uPASS Target dimensions
To Next Page
Loading...
