uPASS Target | installation guide
29/
6.4.2 Decode Nedap-XS
Enable/disable decode Nedap XS formatted tags.
Figure 26: Output settings
By default the data on Nedap-XS formatted tags is transmitted to the TRANSIT compatible processor and the Nedap
antenna modulation interface. In this case the uPASS will not perform any decoding.
Enable the 'decode Nedap XS' option to decode the Nedap XS tag data and output its plain tag-number. In this case the
TRANSIT compatible processor and the antenna modulation interface are not used. Additionally this function can be
used to verify or output the customer code.
Enable the option 'Allow other tag formats' when the reader should also support other formatted tags, such as Nedap
UHF Wiegand formatted tags and others.
See the uPASS decode Nedap XS Application Note for more information.
TRANSIT compatible mode
When using the TRANSIT compatible mode ensure that the 'decode Nedap XS' option is disabled!!!
Set the virtual DIP switches with the checkboxes 1-7 (see TRANSIT firmware guide). The box “TRANSIT compatible
mode” indicates if TRANSIT compatible mode is currently enabled (green=yes). The actual TRANSIT compatible mode
itself is set with SW1-1. See chapter 4.
To Next Page
Loading...
