uPASS Target | installation guide
35/
6.5.6 Antenna
Antenna settings can be changed in the Antenna panel.
With the “antenna select” setting the mode of antenna operation can be selected.
Choose either “internal only”, “external only” or “internal + external”.
For the Internal and External antenna the output power can be configured. This is the same setting as the “Antenna
output power” from the read range (see chapter 6.5.5).
With “Dwell time” the maximum ON time of the antenna is configured. The maximum ON time is the time in
milliseconds that the antenna is activated during a tag identification round. If configured to zero there is no maximum
ON time.
The “Inventory cycles” are the amount of cycles the reader tries to find all tags within a tag identification round. The
uPASS Target reader can find up to 4 tags every cycle.
If “Dwell time” and “Inventory cycles” are both set, the time which is the shortest will be used. Both settings may not
be configured to zero.
Figure 35: Antenna
To Next Page
Loading...
