Net.Do FOX1024s - 5.4.1 Save File; 5.4.2 Read File; 5.4.3 Delete File; 5.5 Other Setting

Net.DO Lighting Control Equipment Co.,Ltd http://www.netdo.com.cn
FOX1024s Moving Light Controller. PAGE: 16
5.3.2 Invert attribute value
Path: SETUP  Fixture  FixInvert
In FixInvert menu, the value sequence of Dimmer
can be inverted, Pan & Tilt can be inverted or
swapped.
CLR Soft Key --- used to clear invert of the selected fixture; Press and hold CLR soft key for 2
seconds, invert of all fixtures will be cleared.
5.4 Data File
It’s necessary to use different data according to different occasions and users; and to prevent data
modified by others, the best way is to backup data by U-disk. In DataFile menu, data can be saved and
used. Data file supports FAT16 / FAT32 format and is compatible with NetDO EXP/ET series consoles.
Path: SETUP  DataFile
5.4.1 Save File
In DataFile menu, data can be saved in U-disk.
Insert U-disk, press SaveFile (F1) soft key to enter
SaveFile menu, then select file name (FOX01~99) by
 Cursor Key or Wheel A/B, and press ENTER soft key to save all the data into U-disk.
Remark: The new file will cover the old one in the U-disk if their file names are the same！
5.4.2 Read File
In DataFile menu, data in the U-disk can be recovered to the console.
Insert U-disk, press ReadFile (F2) soft key to enter
ReadFile menu, then select the file and press ENTER
soft key to read the data file into the console.
Remark: The read file will cover the original one in the console.
5.4.3 Delete File
In DataFile menu, data files in the U-disk can be deleted.
Insert U-disk, press DEL File (F4) soft key to enter DEL File menu, then select the file and press
ENTER soft key to delete.
DataFile
SaveFile
(F1)
ReadFile
(F2)
DEL File
(F4)