Net.Do FOX1024s - 11. Synchronous Parallel Operation; 12. Light Show (Auto Playback); 12.1 External Time Code (MIDI)

Net.DO Lighting Control Equipment Co.,Ltd http://www.netdo.com.cn
FOX1024s Moving Light Controller. PAGE: 33
 Record:
Set the console in “Master” status, connect it with PC and run Cubase to start recording.
*TIPS: After the record starts, it is recommended to pull all the Playback faders to bottom and press
key CLEAR
. The console will send the initial parameters to the computer for recording.
 Play:
Set the console in “Slave” status, connect it with PC and run Cubase to start playing back.
*TIPS: Under “Slave” status, pressing CLEAR Key will clear all the running data of the console.
12.2 Internal Time Code (One Key Light Show)
There are 20 keys for recording “One Key Light Show” in the console to achieve “Light Show”
(without PC).
Press and hold SHOW Key for 2sec to enter “Slave” status (Light Show), the indicator of SHOW will be
bright, the 1~20 Numeric Keys will be used as internal “Light Show” key. (TIPS: Press and hold SHOW
key for 2sec again, the console will be back to “Master” status)
Under “Slave” status, the following operation of “One Key Light Show” is archievable:
 Record: 1) Press and hold key RECORD  Press “Light Show” Numeric Key to prepare for
recording.
2) The recording will start when there is recordable operation (like push faders, turn pages
etc.)
*TIPS: it’s recommended to press key CLEAR after the recording starts, in order to clear
the outputting data and record the initial parameters.
3) Press the ”Light Show” Numeric Key again to end recording.
 Play: Press corresponding Numeric Key to start playing. (TIPS: Press it again to stop playing)
 Copy: Press and hold COPY Key  Press a Numeric Key(copy)  Press another Numeric
Key(paste);
 Delete: Press and hold DELETE Key  Press corresponding Numeric Key to delete;
13. Priority Levels of Different Operations
Priority Levels of different operations are as follows:
Manual-Run Fixture
(Priority over)  SCENE (Priority over)  Playback
 Priority between Playbacks:
Priority between Playbacks is according to the rules of HTP and LTP channel mentioned above.
(HTP is “Highest value takes precedence”; LTP is “Latest value takes precedence”.)
 Priority between Scenes:
Between Scenes, all channels will be output according to the rule of HTP, which is more
convenient to superimpose scenes.
 Priority between SCENE and Playback:
Between SCENE and Playback, HTP channels will be output according to the rule of HTP; LTP
channels will output the value of SCENE. (It means SCENE can superpose on Playback,