Net.DO Lighting Control Equipment Co.,Ltd http://www.netdo.com.cn
FOX1024s Moving Light Controller. PAGE: 20
6.6 Parity selecting and one by one control of fixtures
Multiple selected fixtures can be controlled in the order of odd number / even number or one by one.
6.6.1 Parity selecting of fixtures
1) Select multiple fixtures;
2) Press Prev Next key at the same time to switch to the fixtures of odd number;
3) Press the above keys again to switch to the fixtures of even number;
4) Press the above keys again to exit parity selecting.
6.6.2 One by one control of fixtures
Multiple fixtures can be controlled one by one. This function is very useful in editing Pan/Tilt, Pan/Tilt
of selected fixtures can be fast edited one by one instead of being selected repeatedly. Operation:
1) Select multiple fixtures;
2) Press Prev or Next key continuously, fixtures can be selected individually in sequence.
3) Pressing the above keys at the same time will exit selecting.
6.7 FAN function
FAN function is to expand the attributes of selected fixtures. Among the selected fixtures, attributes
of the first fixture and the last one change the most, and gradually descend to the middle, to achieve
gradient effect. If use FAN to expand the Pan/Tilt attributes, the fixtures will show fan beam.
FAN is usually used in editing Pan/Tilt, it can also be used in other attributes such as Dimmer.
Operation of FAN:
1) Select fixtures;
2) Press Attribute Key to select attributes;
3) Press FAN key (its indicator will flash and the LCD screen show as right);
4) Rotate Wheel A/B to set the value (Range: +/- 50, the effect is according to the selected attribute);
5) Press FAN key again (its indicator will go out) to exit.
6.8 MODIFY function
When the edit of Pan/Tilt is manually finished, the MODIFY function can be used to modify these
Pan/Tilt together as a whole while keep their relative position unchanged.
Press MODIFY key, its indicator will flash, which means it’s under the MODIFY mode; the value of
selected fixtures will change relatively instead of becoming the same if their attribute is modified.
MODIFY is usually used in editing Pan/Tilt, it can also be used in other attributes such as Dimmer.
*TIPS: In the modification of Pan/Tilt, this function is more suitable for the fixtures mounted in line.
6.9 Reference Fixture
Multiple fixtures will align to a Reference Fixture when their attribute is manually modified.
To Next Page
Loading...