Net.Do FOX1024s - 6.2 Clear Manual-Run Fixture; 6.3 FIND function; 6.4 LOCATE function; 6.5 GROUP function

Net.DO Lighting Control Equipment Co.,Ltd http://www.netdo.com.cn
FOX1024s Moving Light Controller. PAGE: 19
3) Control attributes by Attribute Fader:
Except Wheel A/B, Attribute Fader can also be used to modify attributes.
*TIPS1: Set Attribute Fader to “attribute mode” before using.
*TIPS2: Attributes can be modified by fader only when the fader value is higher than the current
value.
6.2 Clear Manual-Run Fixture
There are 2 ways of clearing manual-run fixture:
 Clear All: Press CLEAR, all fixture selecting will be cancelled and value will be cleared.
 Clear certain fixture: Press and hold CLEAR  press corresponding Fixture Numeric Keys.
(Clear multiple fixtures by multiple selections)
*TIPS1: After the data of manual-run is cleared, shielded playbacks & scenes will restore outputting.
*TIPS2: Before manual-run fixture, it’s recommended to press CLEAR firstly to clear all data of
manual-run, in order to avoid the output of unwanted value.
6.3 FIND function
The “FIND” function is to light up and fixtures for fast checking. Operation of “FIND” will not affect the
value of manual-run (no value is given). This function requires the support of related data in library.
Press FIND key, the indicator will flash slowly which means it’s in FIND status, press it again to exit;
In FIND status, selected fixtures will be centered and lighted up (without value), Dimmer channel will
be full and unaffected by Master Faders. Only the manually modified data will be saved after exiting.
TIPS: FIND function is recommended in editing Presets or recording Scenes, in order to show
fixtures while avoid recording the data of Dimmer and Pan/Tilt.
6.4 LOCATE function
The “LOCATE” function is to light up and locate fixtures for fast checking (will give value to each
channel). Select fixtures and press LOCATE key, the fixtures will be centered and lighted up. This
function requires the support of related data in library.
Remark:”LOCATE” function will give value to all channels of the selected fixtures.
6.5 GROUP function
GROUP function is to organize the frequently used fixtures into groups for fast selecting.
 Call Group: Press GROUP key to enter group status  Press Numeric Key (Group No.)
 Record Group: Select fixtures  press and hold RECORD key  Press Group Numeric Key
 Delete Group: Press and hold DELETE  Press Group Numeric Key.
 Copy Group: Press and hold COPY key  Press Group Numeric Key (source)
 Press another Group Numeric Key (target).