Management node overview
You can use the management node (mNode) to use system services, manage cluster
assets and settings, run system tests and utilities, configure Active IQ for system
monitoring, and enable NetApp Support access for troubleshooting.
For clusters running Element software version 11.3 or later, you can work with the management node by using
one of two interfaces:
•
With the management node UI (https:// [mNode IP}:442), you can make changes to network and
cluster settings, run system tests, or use system utilities.
•
With the built-in REST API UI (https://[mNode IP}/mnode), you can run or understand APIs relating
to the management node services, including proxy server configuration, service level updates, or asset
management.
Install or recover a management node:
• Install a management node
• Configure a storage Network Interface Controller (NIC)
• Recover a management node
Access the management node:
• Access the management node (UI or REST API)
Perform tasks with the management node UI:
• Management node UI overview
Perform tasks with the management node REST APIs:
• Management node REST API UI overview
Disable or enable remote SSH functionality or start a remote support tunnel session with NetApp Support to
help you troubleshoot:
• Enable remote NetApp Support connections
• Manage SSH functionality on the management node
Find more information
• NetApp Element Plug-in for vCenter Server
• NetApp HCI Resources Page
Install or recover a management node
Install a management node
You can manually install the management node for your cluster running NetApp Element
software using the appropriate image for your configuration.
To Next Page
Loading...
Need help?
General
