window that is displayed:
i. For connection type, select VMkernel Network Adapter, and select Next.
ii. For target device, select the option to use an existing standard switch, browse to vSwitch2, and
select Next.
iii. Under port properties, change the network label to iSCSI-A, and select Next.
iv.
Under IPv4 settings, provide the IPv4 information, and select Next.
The IP address you enter here is the iSCSI-A IP address that you copied earlier.
v. If you are ready to proceed, select Finish.
m. In the graphic that is displayed, select iSCSI-A, and select the pencil icon to edit the settings as
follows:
i. Select Security, and make the following selections:
ii. Select Teaming and failover, and select the Override checkbox.
iii. Move vmnic5 to Unused adapters by using the arrow icon.
iv. Select OK.
n. With the newly added node selected and the Manage tab open, select Storage > Storage Adapters,
and perform the following steps:
i. Select + and select Software iSCSI Adapter.
ii. To add the iSCSI adapter, select OK in the dialog box.
iii. Under Storage Adapters, select the iSCSI adapter, and from the Properties tab, copy the iSCSI
Name.
You need the iSCSI Name when you create the initiator.
To Next Page
Loading...
Need help?
General
