NETGEAR GS716T

140
GS716T and GS724T Gigabit Smart Switches
Talker Declaration Type Identifies the MSRP declaration type of the talker attribute.
Accumulated Latency Identifies how much latency, in nanoseconds, the stream has suffered
in its path from the Talker to a given Listener. It starts as a 0 in a Talker
Advertise Declaration at the Talker, and its value is increased by one
for each bridge as the Talker Advertise Declaration propagates through
the network.
Failure Bridge Interface Identifies the interface on the Bridge where the failure occurred.
Failure Code Shows the number that represents the reason for the failure. The
switch supports the following codes:
• 1—Insufficient bandwidth
• 3—Insufficient bandwidth for the traffic class
• 5—Stream destination_address is already in use
• 7—Reported latency has changed
• 8—Egress port is not Audio/Video Bridging (AVB) capable
• 9—Use a different destination_address (i.e. MAC DA hash table
full)
• 12—Cannot store destination_address (i.e., Bridge is out of MAC
DA resources)
• 13—Requested priority is not an SR Class priority
• 14—MaxFrameSize is too large for media
• 15—msrpMaxFanInPorts limit has been reached
• 16—Changes in FirstValue for a registered StreamID
• 17—VLAN is blocked on this egress port (Registration Forbidden)
Failure Bridge MAC Identifies the MAC address of the switch where the failure occurred.
Stream Age The time, in seconds, since the stream destination address was added
to the Dynamic Reservations Entries table. A value of zero indicates
the destination address has not been added to the table.
Field Description