223
GS716T and GS724T Gigabit Smart Switches
To create an IPv6 ACL:
1. To add an ACL, type a name in the IPv6 ACL field, and then click Add.
2. To delete an ACL, select the check box associated with the ACL, and then click Delete.
3. Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
4. If you modify the IPv6 ACL name, click Apply to submit the changes to the switch.
IPv6 Rules
Use the IPv6 Rules page to configure the rules for the IPv6 Access Control Lists. The IPv6
Access Control Lists are created using the IPv6 Access Control List Configuration page. By
default, no specific value is in effect for any of the IPv6 ACL rules.
To display the IPv6 Rules page, click Security
ACL > Advanced IPv6 Rules. In the
following figure, an IPv6 rule exists, and one rule has been configured.
To Next Page
Loading...
