EasyManuals Logo

NETGEAR GS716T User Manual

NETGEAR GS716T
303 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #50 background imageLoading...
Page #50 background image
50
GS716T and GS724T Gigabit Smart Switches
Green Ethernet Configuration
Use this page to configure the administrative mode for the Green Ethernet features available
on the switch. These features must also be enabled on each port to take advantage of the
possible power savings.
To access this page, click System
Management Green Ethernet Configuration.
To configure the Green Ethernet feature:
1. Enable or disable the Auto Power Down Mode.
Enable. When the port link is down, the PHY will automatically go down for a short
period of time and then wake up to check link pulses. This allows the port to continue
to perform auto-negotiation while consuming less power when no link partner is
present.
Disable. Provide full power to the port even if no link partner is present.
2. Enable or disable the Short Cable Mode.
Enable. The switch performs a cable test when the port link is up. If the cable that
connects the port to its link partner has a length less than 10m, PHYs are placed in
low-power mode (nominal power).
Disable. Do not perform an automatic cable test on a linked port or adjust the port
power based on the cable length.
3. Click Apply to send the updated configuration to the switch. Configuration changes take
effect immediately.

Table of Contents

Other manuals for NETGEAR GS716T

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NETGEAR GS716T and is the answer not in the manual?

NETGEAR GS716T Specifications

General IconGeneral
Switch typeManaged
Switch layerL3
Quality of Service (QoS) supportYes
Stackable-
CertificationCE, FCC, VCCI, EN, C-Tick, CCC, CSA, UL/cUL, IEC
Product colorBlue
LED indicatorsActivity, Link, Power
SFP module slots quantity2
Basic switching RJ-45 Ethernet ports typeGigabit Ethernet (10/100/1000)
Basic switching RJ-45 Ethernet ports quantity16
Number of VLANs256
Networking standardsIEEE 802.1D, IEEE 802.1as, IEEE 802.1s, IEEE 802.1v, IEEE 802.3, IEEE 802.3ab, IEEE 802.3ad, IEEE 802.3i, IEEE 802.3u, IEEE 802.3x, IEEE 802.3z
Copper ethernet cabling technology10BASE-T, 100BASE-TX, 100BASE-T, 1000BASE-T
Noise level0 dB
Mean time between failures (MTBF)567680 h
DHCP featuresDHCP client
Security algorithms802.1x RADIUS, HTTPS, SSL/TLS
AC input voltage100 - 240 V
AC input frequency50 - 60 Hz
Power consumption (typical)14.4 W
MAC address table16000 entries
Number of static routes32
Operating altitude0 - 3000 m
Storage temperature (T-T)-20 - 70 °C
Operating temperature (T-T)0 - 50 °C
Storage relative humidity (H-H)0 - 95 %
Operating relative humidity (H-H)0 - 90 %
Cables includedAC
Supported network protocolsIP
Weight and Dimensions IconWeight and Dimensions
Depth204 mm
Width440 mm
Height43 mm
Weight2570 g

Related product manuals