NETGEAR GS716T

98
GS716T and GS724T Gigabit Smart Switches
Auto-VoIP Configuration
The Auto-VoIP automatically makes sure that time-sensitive voice traffic is given priority over
data traffic on ports that have this feature enabled. Auto-VoIP checks for packets carrying the
following VoIP protocols:
• Session Initiation Protocol (SIP)
• H.323
• Skinny Client Control Protocol (SCCP)
VoIP frames that are received on ports that have the Auto-VoIP feature enabled are marked
with CoS Traffic Class 3.
Use the Auto-VoIP Configuration menu to configure the Auto-VoIP parameters. Interface
specifies all the configurable Auto-VoIP interfaces. Traffic Class displays the Traffic Class on
which the received VoIP frames are marked.
To display the Auto-VoIP Configuration page, click Switching
 Auto-VoIP.
To enable Auto-VoIP:
1. Auto-VoIP Mode. Select the Auto-VoIP administrative mode for the interface. This
selector lists the two options for administrative mode: Enable and Disable. The
administrative mode of Auto-VoIP is disabled by default.
2. Click Cancel to cancel the configuration on the screen and reset the data on the screen to
the latest value of the switch.
3. If you make any configuration changes, click Apply to send the updated configuration to the
switch. Configuration changes occur immediately.