NETGEAR GS716T

200
GS716T and GS724T Gigabit Smart Switches
Traffic Control
From the Traffic Control link, you can configure MAC Filters, Storm Control, Port Security,
and Protected Port settings. To display the page, click the Security
 Traffic Control tab.
The Traffic Control folder contains links to the following features:
• MAC Filter:
• MAC Filter Configuration on page 200
• MAC Filter Summary on page 202
• Storm Control on page 203
• Port Security:
• Port Security Configuration on page 204
• Port Security Interface Configuration on page 205
• Security MAC Address on page 207
• Protected Ports Membership on page 208
MAC Filter Configuration
Use the MAC Filter Configuration page to create MAC filters that limit the traffic allowed into
and out of specified ports on the system.
To display the MAC Filter Configuration page, click Security  Traffic Control, and then click
the MAC Filter
 MAC Filter Configuration link.
In the following figure, the source and destination port member areas have been expanded to
show the ports. Click the orange bar to show the ports or LAGs.