EasyManuals Logo

NETGEAR Nighthawk R7000P User Manual

NETGEAR Nighthawk R7000P
155 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #150 background imageLoading...
Page #150 background image
If your WiFi device finds your network but the signal strength is weak, check these conditions:
Is your router too far from your computer or too close? Place your computer near the router but at least
6 feet (1.8 meters) away and see whether the signal strength improves.
Are objects between the router and your computer blocking the WiFi signal?
Troubleshoot Your Network Using the Ping Utility
Most network devices and routers contain a ping utility that sends an echo request packet to the designated
device.The device then responds with an echo reply.You can easily troubleshoot a network using the ping
utility in your computer or workstation.
Test the LAN Path to Your Router
You can ping the router from your computer to verify that the LAN path to your router is set up correctly.
To ping the router from a Windows computer:
1. From the Windows toolbar, click the Start button and select Run.
2. In the field provided, type ping followed by the IP address of the router, as in this example:
ping www.routerlogin.net
3. Click the OK button.
You see a message like this one:
Pinging <IP address > with 32 bytes of data
If the path is working, you see this message:
Reply from < IP address >: bytes=32 time=NN ms TTL=xxx
If the path is not working, you see this message:
Request timed out
If the path is not functioning correctly, one of the following problems might be occuring:
Wrong physical connections
For a wired connection, make sure that the numbered LAN port LED is lit for the port to which you are
connected.
Check to see that the appropriate LEDs are lit for your network devices. If your router and computer are
connected to a separate Ethernet switch, make sure that the link LEDs are lit for the switch ports that
are connected to your computer and router.
Wrong network configuration
Verify that the Ethernet card driver software and TCP/IP software are both installed and configured on
your computer.
Verify that the IP address for your router and your computer are correct and that the addresses are on
the same subnet.
Troubleshooting
150
Nighthawk AC2300 Smart WiFi Router

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NETGEAR Nighthawk R7000P and is the answer not in the manual?

NETGEAR Nighthawk R7000P Specifications

General IconGeneral
DSL WANNo
Ethernet WANYes
3G/4G USB modem compatibility-
Wi-Fi bandDual-band (2.4 GHz / 5 GHz)
Top Wi-Fi standardWi-Fi 5 (802.11ac)
WLAN data transfer rate (max)2225 Mbit/s
WLAN data transfer rate (first band)1625 Mbit/s
WLAN data transfer rate (second band)600 Mbit/s
Cabling technology10/100/1000Base-T(X)
Networking standardsIEEE 802.11a, IEEE 802.11ac, IEEE 802.11b, IEEE 802.11g, IEEE 802.11n
Ethernet LAN data rates10, 100, 1000 Mbit/s
Ethernet LAN interface typeGigabit Ethernet
USB 2.0 ports quantity1
Ethernet LAN (RJ-45) ports5
Security algorithmsWEP, WPA, WPA2-PSK
Antennas quantity3
Product typeTabletop router
Product colorBlack
LED indicatorsPower
Processor cores2
Processor frequency1000 MHz
Power source typeAC
Weight and Dimensions IconWeight and Dimensions
Depth184.5 mm
Width285 mm
Height50 mm
Weight750 g

Related product manuals