Front View
The router has status LEDs on top and a USB 3.0 port on the front
Figure 2. Front view
LED Descriptions
The following tables describe the LEDs and buttons on the top of the router.
Table 1. LED descriptions
DescriptionLED
• Solid amber.The router is starting.
• Blinking amber.The firmware is upgrading, or the Reset button was pressed.
• Solid white.The router is ready.
• Blinking white.The firmware is corrupted.
• Off. Power is not supplied to the router.
Power
• Solid white.The Internet connection is ready.
• Solid amber.The router has detected an Ethernet cable connection to the modem.
• Blinking white.The port is sending or receiving traffic.
• Off. No Ethernet cable is connected between the router and the modem.
Internet
Hardware Setup
10
Nighthawk AC2300 Smart WiFi Router
To Next Page
Loading...
