EasyManuals Logo

NETGEAR ProSafe GSM7224 User Manual

NETGEAR ProSafe GSM7224
228 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #119 background imageLoading...
Page #119 background image
User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
Switching Commands 8-67
202-10009-01_060204
Mode Global Config
Acceptable values are:
100h 100BASE-T half-duplex
100f 100BASE-T full duplex
10h 10BASE-T half duplex
10f 100BASE-T full duplex
storm-control broadcast
This command enables broadcast storm recovery mode. If the mode is enabled, broadcast storm
recovery with high and low thresholds is implemented.
The threshold implementation follows a percentage pattern. If the broadcast traffic on any Ethernet
port exceeds the high threshold percentage (as represented in “Broadcast Storm Recovery
Thresholds” table) of the link speed, the switch discards the broadcasts traffic until the broadcast
traffic returns to the low threshold percentage or less. The full implementation is depicted in the
“Broadcast Storm Recovery Thresholds” table.
Format
switchconfig storm-control broadcast
Mode Global Covnfig
no storm-control broadcast
This command disables broadcast storm recovery mode.
The threshold implementation follows a percentage pattern. If the broadcast traffic on any Ethernet
port exceeds the high threshold percentage (as represented in “Broadcast Storm Recovery
Thresholds” table) of the link speed, the switch discards the broadcasts traffic until the broadcast
traffic returns to the low threshold percentage or less. The full implementation is depicted in the
“Broadcast Storm Recovery Thresholds” table.
Table 8-1. Broadcast Storm Recovery Thresholds
Link Speed High Low
10M 20 10
100M 5 2
1000M 5 2

Table of Contents

Other manuals for NETGEAR ProSafe GSM7224

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the NETGEAR ProSafe GSM7224 and is the answer not in the manual?

NETGEAR ProSafe GSM7224 Specifications

Performance Specifications IconPerformance Specifications
forwarding modesStore-and-forward
bandwidth48 Gbps
switch latencyLess than 20 microseconds for 64-byte frames
system memory64 MB
packet buffer memory122 KB embedded memory per port
code storage8 MB
address database size8, 000 MAC addresses
addressing48-bit MAC address
number of VLANs228
number of trunks6
number of queues4
acoustic noise60 dB
heat dissipation28.24 Btu/hr
mean time between failure58, 300 hours
Electrical Specifications IconElectrical Specifications
power consumption36 W
input voltage100-240VAC
input frequency50-60 Hz
Physical Specifications IconPhysical Specifications
width440 mm
depth257 mm
height43 mm
Environmental Specifications IconEnvironmental Specifications
operating temperature0 to 40° C
storage temperature-20 to 70° C
operating humidity90% maximum relative humidity
storage humidity95% maximum relative humidity
operating altitude10, 000 ft
storage altitude10, 000 ft

Related product manuals