User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
8-14 Switching Commands
202-10009-01_060204
Note: Message log information is not retained across a switch reset.
show running-config
This command is used to display the current setting of different protocol packages supported on
switch. This command displays only those parameters, the values of which differ from default
value. The output is displayed in the script format, which can be used to configure another switch
with same configuration.
Format
show running-config
Mode Privileged EXEC
show sysinfo
This command displays switch information.
Format
show sysinfo
Mode
Privileged EXEC
Switch Description Text used to identify this switch.
System Name Name used to identify the switch.
System Location Text used to identify the location of the switch. May be up to 31
alpha-numeric characters. The factory default is blank.
System Contact Text used to identify a contact person for this switch. May be up
to 31 alpha-numeric characters. The factory default is blank.
System ObjectID The base object ID for the switch’s enterprise MIB.
System Up Time The time in days, hours and minutes since the last switch reboot.
MIBs Supported A list of MIBs supported by this agent.
snmp-server
This command sets the name and the physical location of the switch, and the organization
responsible for the network.The range for name, location and contact is from 1 to 31 alphanumeric
characters.
Default None
Format
snmp-server {sysname <name> | location <loc> | contact
<con>}
To Next Page
Loading...
