User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
Switching Commands 8-97
202-10009-01_060204
dot1x re-authenticate
This command begins the re-authentication sequence on the specified port. This command is only
valid if the control mode for the specified port is 'auto'. If the control mode is not 'auto' an error
will be returned.
Format dot1x re-authenticate <slot/port>
Mode Privileged EXEC
dot1x re-authentication
This command enables re-authentication of the supplicant for the specified port.
Default Disabled
Format dot1x re-authentication
Mode
Interface Config
no dot1x re-authentication
This command disables re-authentication of the supplicant for the specified port.
Format no dot1x re-authentication
Mode
Interface Config
dot1x system-auth-control
This command is used to enable the dot1x authentication support on the switch. By default, the
authentication support is disabled. While disabled, the dot1x configuration is retained and can be
changed, but is not activated.
Default Disabled
Format dot1x system-auth-control
Mode Global Config
no dot1x system-auth-control
This command is used to disable the dot1x authentication support on the switch.
Format no dot1x system-auth-control
To Next Page
Loading...
