User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
Quick Start up 6-5
202-10009-01_060204
Quick Start up Uploading from Switch to Out-of-Band PC (Only
XMODEM)
Table 6-5. Quick Start up Uploading from Switch to Out-of-Band PC (XMODEM)
Command Details
copy {
nvram:startup-config |
nvram:errorlog |
nvram:msglog |
nvram:traplog} <url>
The types are:
config - configuration file
errorlog - error log
system trace - system trace
traplog - trap log
The URL must be specified as:
xmodem:filepath/fileName
This starts the upload and also displays the mode of
uploading and the type of upload it is and confirms the
upload is taking place.
For example:
If the user is using HyperTerminal, the user must
specify where the file is going to be received by the
PC.
To Next Page
Loading...
