NETGEAR ProSafe GSM7224

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
8-24 Switching Commands
202-10009-01_060204
Remote Connection Login Timeout (minutes) This object indicates the number of
minutes a remote connection session is allowed to remain inac-
tive before being logged off.A zero means there will be no time-
out. May be specified as a number from 0 to 160. The factory
default is 5.
Maximum Number of Remote Connection Sessions This object indicates the num-
ber of simultaneous remote connection sessions allowed. The fac-
tory default is 5.
Allow New Telnet Sessions Indicates that new telnet sessions will not be allowed when
set to no. The factory default value is yes.
show serial
This command displays serial communication settings for the switch.
Format
show serial
Mode Privileged EXEC and User EXEC
Serial Port Login Timeout (minutes) Specifies the time, in minutes, of inactivity on a
Serial port connection, after which the Switch will close the con-
nection. Any numeric value between 0 and 160 is allowed, the
factory default is 5. A value of 0 disables the timeout.
Baud Rate The default baud rate at which the serial port will try to connect.
The available values are 1200, 2400, 4800, 9600, 19200,
38400,57600, and 115200 baud. The factory Default is 9600
baud.
Character Size The number of bits in a character. The number of bits is always 8.
Flow Control Whether Hardware Flow-Control is enabled or disabled. Hard-
ware Flow Control is always disabled.
Stop Bits The number of Stop bits per character. The number of Stop bits is
always 1.
Parity Type The Parity Method used on the Serial Port. The Parity Method is
always None.
show snmpcommunity
This command displays SNMP community information.