NETGEAR ProSafe GSM7224

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
8-2 Switching Commands
202-10009-01_060204
numbers that are separated by colons, for example
01:23:45:67:89:AB
IP Address The IP address assigned to each interface.
slot/port Valid slot number and a valid port number.
show eventlog
This command displays the event log, which contains error messages from the system. The event
log is not cleared on a system reset.
Format
show eventlog
Mode Privileged EXEC
File The file in which the event originated.
Line The line number of the event
Task Id The task ID of the event.
Code The event code.
Time The time this event occurred.
Note: Event log information is retained across a switch reset.
show hardware
This command displays inventory information for the switch.
Format
show hardware
Mode
Privileged EXEC
Description Text used to identify the product name of this switch.
Burned in MAC Address Universally assigned network address.
Software Version The release.version.revision number of the code currently run-
ning on the switch.
show interface
This command displays a summary of statistics for a specific port or a count of all CPU traffic
based upon the argument.
Format
show interface {<slot/port> | switchport}