User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
8-20 Switching Commands
202-10009-01_060204
Default None
Format network protocol {none | bootp | dhcp}, where bootp
indicates that the switch periodically sends requests to a Boot-
strap Protocol (BootP) server or a dhcp server until a response is
received.
none indicates that the switch should be manually con-
figured with IP information.
Mode
Privileged EXEC
remotecon maxsessions
This command specifies the maximum number of remote connection sessions that can be
established. A value of 0 indicates that no remote connection can be established. The range is 0 to
5.
Default 5
Format
remotecon maxsessions <0-5>
Mode
Privileged EXEC
no remotecon maxsessions
This command sets the maximum number of remote connection sessions that can be established to
the default value.
Default 5
Format
no remotecon maxsessions
Mode Privileged EXEC
remotecon timeout
This command sets the remote connection session timeout value, in minutes. A session is active as
long as the session has been idle for the value set. A value of 0 indicates that a session remains
active indefinitely. The time is a decimal value from 0 to 160.
Note: Changing the timeout value for active sessions does not become effective until the session is
reaccessed. Any keystroke will also activate the new timeout duration.
Default 5
Format
remotecon timeout <0-160>
Mode Privileged EXEC
To Next Page
Loading...
