NETGEAR ProSafe GSM7224 - Page 187

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software
IS CLI Mapping A-11
202-10009-01_060204
Switching show loginsession Privileged
EXEC
show loginsession
Switching config users add <name> Global
Config
users name <username>
Switching config users delete <name> Global
Config
no users name <username>
Switching config users passwd <user> Global
Config
users passwd <username>
Switching config users snmpv3
authentication <user> <none/md5/
sha>
Global
Config
users snmpv3 authentication
<username> {none | md5 | sha}
Global
Config
no users snmpv3 authentication
<username>
Switching config users snmpv3 encryption
<user> <none/des [key]>
Global
Config
users snmpv3 encryption
<username> {none | des [key]}
Global
Config
no users snmpv3 encryption
<username>
Switching config users snmpv3 accessmode
<user> <readonly/readwrite>
Global
Config
users snmpv3 accessmode
<username> {readonly | readwrite}
Global
Config
no users snmpv3 accessmode
<username>
Switching config loginsession close
<sessionID/all>
Privileged
EXEC
disconnect {<sessionID> | all}
Switching show switchconfig Privileged
EXEC
show storm-control
Switching show port <slot/port | all> Privileged
EXEC
show port {<slot/port> | all}
Switching show lag <logical slot/port | all> Privileged
EXEC
show port-channel {<logical slot/port>
| all}
Table 9-1. IS CLI Mapping (continued)
Package 7200 Series L2 Switch Command
CLI Command
Mode Syntax