NETGEAR ProSAFE M4300 series User Manual

Step 5: Check the Installation..............................................................................45
Optional Step 6: Install SFP Transceiver Modules...............................................46
Install an SFP Transceiver Module.......................................................................47
Install an SFP Module into a Model M4300-48X..................................................47
Step 7: Apply AC Power and Check the LEDs.....................................................48
Optional Step 8: Install a Second Power Supply Unit..........................................49
Optional Step 9: Connect a Redundant Power Supply........................................50
Optional Step 10: Connect a Console to the Switch............................................50
Optional Step 11: Replace a Half-width Switch in a Rack....................................51
Chapter 4 Maintenance and Troubleshooting
Replace a Power Supply Unit..............................................................................55
Troubleshooting Chart..........................................................................................56
Additional Troubleshooting Suggestions..............................................................58
3
Managed Stackable Switch Series M4300

NETGEAR ProSAFE M4300 series Specifications

General

Stackable	Yes
Series	ProSAFE M4300
Layer	L3
Ports	Varies by model (24, 48 ports)
PoE	Available on some models (PoE+)
Management	Web, CLI, SNMP
Redundancy	Yes (dual power supplies on select models)
Form Factor	Rack-mountable
Throughput	Varies by model
Switching Capacity	Varies by model
Jumbo Frame Support	Yes
VLAN Support	Yes
Quality of Service (QoS)	Yes
Security Features	ACLs, 802.1x
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	0° to 50° C (32° to 122° F)
Storage Temperature	-4°F to 158°F (-20°C to 70°C)
Humidity	95% relative humidity, non-condensing
Power Supply	Varies by model
Warranty	Lifetime