Configure Switching
104
ProSAFE 10-Gigabit Smart Managed Switch XS728T and XS748T User Manual
Manually Add Members to or Remove Them From a MAC-Based
VLAN Group
To add members to or remove them from a MAC-based VLAN group:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Change the Default IP Address of the
Switch on page 10.
The login window opens.
4. Enter the switch’s password in the Password field.
The default password is password.
The System Information page displays.
5. Select Switching > VLAN > Advanced > MAC Based VLAN Group Membership.
6. In the Group ID menu, select the group ID.
7. In the VLAN ID menu, select the VLAN ID.
8. In the Ports table, click the port once to add it to the VLAN for the group or twice to remove
it from the VLAN for the group.
By default, the selection is blank, which means that the port is excluded from the VLAN
for the group.
9. In the LAG table, click the LAG once to add it to the VLAN for the group or twice to remove
it from the VLAN for the group.
By default, the selection is blank, which means that the LAG is excluded from the VLAN
for the group.
10. Click the Apply button.
To Next Page
Loading...
Need help?
General
