Configure Routing
179
ProSAFE 10-Gigabit Smart Managed Switch XS728T and XS748T User Manual
Configure IPv6
IPv6 is supported only on VLAN interfaces, not on physical ports.
From the Routing > IPv6 > Advanced menu, you can access pages that are described in
the following sections:
• Configure IPv6 Global Settings on page 179
• Add a Static IPv6 Route on page 180
• View the IPv6 Route Table on page 183
• Configure IPv6 VLAN Interface Settings on page 184
• Add an IPv6 Global Address to an IPv6 VLAN on page 186
• Add an IPv6 Prefix for Advertisement on an IPv6 VLAN on page 189
• View IPv6 Statistics for an Interface on page 192
• View or Clear the IPv6 Neighbor Table on page 195
Configure IPv6 Global Settings
You can configure IPv6 routing parameters for the switch, as opposed to for an interface.
To configure IPv6 global settings:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Change the Default IP Address of the
Switch on page 10.
The login window opens.
4. Enter the switch’s password in the Password field.
The default password is password.
The System Information page displays.
5. Select Routing> IPv6 > Basic > Global Configuration.
To Next Page
Loading...
Need help?
General
