NETGEAR ProSafe XS728T User Manual

Configure Routing
175
ProSAFE 10-Gigabit Smart Managed Switch XS728T and XS748T User Manual
Display the ARP Cache
You can display ARP entries in the ARP cache based on the remote connections most
recently detected switch.
 To display ARP entries in the ARP cache:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Change the Default IP Address of the
Switch on page 10.
The login window opens.
4. Enter the switch’s password in the Password field.
The default password is password.
The System Information page displays.
5. Select Routing> ARP > Basic > ARP Cache.
6. To refresh the page with the latest information about the switch, click the Update button.
The following table describes the nonconfigurable information displayed on the page.
Table 45. ARP cache information
Field Description
Interface The routing interface associated with the ARP entry.
IP Address The IP address of the device (on a subnet) that is attached an existing routing
interface of the switch.
MAC Address The unicast MAC address of the attached device. The address is six two-digit
hexadecimal numbers separated by colons, for example, 00:06:29:32:81:40.
Type The type of ARP entry. Possible values are as follows:
• Static. An ARP entry that was manually configured.
• Dynamic. An ARP entry that was learned by the router.

NETGEAR ProSafe XS728T Specifications

General

Brand	NETGEAR
Model	ProSafe XS728T
Category	Switch
Language	English