Manage Device Security
296
ProSAFE 10-Gigabit Smart Managed Switch XS728T and XS748T User Manual
8. Modify the extended IP ACL rule criteria.
9. Click the Apply button.
The updated configuration is sent to the switch. Configuration changes take effect
immediately.
Delete an Extended IP ACL Rule
To delete an extended IP ACL rule:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Change the Default IP Address of the
Switch on page 10.
The login window opens.
4. Enter the switch’s password in the Password field.
The default password is password.
The System Information page displays.
5. Select Security > ACL > Advanced > IP Extended Rules.
The Extended IP Rules page displays.
6. From the ACL ID menu, select the ACL that includes the rule that you want to delete.
7. In the Extended ACL Rule Table, select the check box for the rule.
8. Click the Delete button.
The rule is removed.
Configure an IPv6 ACL
An IP or IPv6 ACL consists of a set of rules that are matched sequentially against a packet.
When a packet meets the match criteria of a rule, the specified rule action (Permit or Deny) is
taken, and the additional rules are not checked for a match. On this page the interfaces to
which an IP ACL applies must be specified, as well as whether it applies to inbound or
outbound traffic. You can create rules for the IPv6 ACL on the IPv6 Rules page.
To Next Page
Loading...
Need help?
General
