Manage Device Security
295
ProSAFE 10-Gigabit Smart Managed Switch XS728T and XS748T User Manual
subnet, enter 0.0.0.255 in the Dst IP Mask field. This field is required when you
configure a destination IP address.
• Destination L4 port. The options are available only when the protocol is set to TCP or
UDP. Use the destination L4 port option to specify relevant matching conditions for L4
port numbers in the extended ACL rule.
The destination port protocols are domain, echo, ftp, ftpdata, http, smtp, snmp,
telnet, tftp, and www. Each of these values translates into its equivalent port number.
Select Other from the menu to enter a port number from 0 to 65535.
• Service Type. Select either the None radio button to ignore a service type match
condition or the IP DSCP radio button for an IP DSCP service type match condition
for the extended IP ACL rule.
If you select the IP DSCP radio button, select one of the IP DiffServ Code Point
(DSCP) keywords from the menu. The DSCP is defined as the high-order 6 bits of the
service type octet in the IP header. To specify a numeric value, select Other from the
menu and enter a numeric value from 0 to 63.
9. Click the Apply button.
The updated configuration is sent to the switch. Configuration changes take effect
immediately.
Modify the Match Criteria for an Extended IP ACL Rule
 To modify the match criteria for an existing extended IP ACL rule:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Change the Default IP Address of the
Switch on page 10.
The login window opens.
4. Enter the switch’s password in the Password field.
The default password is password.
The System Information page displays.
5. Select Security > ACL > Advanced > IP Extended Rules.
The IP Extended Rules page displays.
6. From the ACL ID menu, select the ACL that includes the rule that you want to modify.
7. In the Extended ACL Rule Table, click the rule.
The rule is a hyperlink. The Extended ACL Rule Configuration page displays.
To Next Page
Loading...
Need help?
General