To Next Page

To Previous Page

Configure Switching

160

ProSAFE 10-Gigabit Smart Managed Switch XS728T and XS748T User Manual

Change the Aging-Out Period of Dynamic MAC Addresses

You can change the aging-out period after which a learned MAC address entry that is not

updated is automatically removed from the forwarding database. By default, this period is 300

seconds. The forwarding database contains static entries, which never age out, and

dynamically learned entries, which are removed if they are not updated before the aging-out

period expires.

 To change the aging-out period of dynamic MAC addresses.

1. Connect your computer to the same network as the switch.

You can use a WiFi or wired connection to connect your computer to the network, or

connect directly to a switch that is off-network using an Ethernet cable.

2. Launch a web browser.

3. In the address field of your web browser, enter the IP address of the switch.

If you do not know the IP address of the switch, see Change the Default IP Address of the

Switch on page 10.

The login window opens.

4. Enter the switch’s password in the Password field.

The default password is password.

The System Information page displays.

5. Select Switching > Address Table > Address Table > Advanced > Dynamic Address.

The Dynamic Address page displays.

6. In the Address Aging Timeout (seconds) field, enter the aging-out period in seconds.

The range 10 to 630 seconds. The default value is 300 seconds.

7. Click the Apply button.

The updated configuration is sent to the switch. Configuration changes take effect

immediately.

Add a Static MAC Address

 To add a static MAC address: