Manage Device Security
244
ProSAFE 10-Gigabit Smart Managed Switch XS728T and XS748T User Manual
This enables or disables the administrative mode of secure HTTP (HTTPS). The
configured value is displayed. The default value is Disable. You can download SSL
certificates only when the HTTPS admin mode is disabled. HTTPS admin mode can be
enabled only if a certificate is present on the device.
7. In the HTTPS Port field, enter the HTTPS port number.
The value must be in the range of 1 to 65535. Port 443 is the default value. The
configured value is displayed.
8. In the HTTPS Session Soft Timeout (Minutes) field, enter the inactivity time-out for HTTPS
sessions.
The value must be in the range of 1 to 60 minutes. The default value is 10 minutes.
9. Click the Apply button.
The updated configuration is sent to the switch. Configuration changes take effect
immediately.
The Maximum Number of HTTPS Sessions field shows the maximum number of HTTPS
sessions that can exist at the same time, which is 2 sessions. This number is not
configurable.
Manage the Certificate
Use the Certificate Management page to manage the certificate. The switch can contain a
single certificate (or set of certificates.)
Generate a Certificate
To generate a certificate:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Change the Default IP Address of the
Switch on page 10.
The login window opens.
4. Enter the switch’s password in the Password field.
The default password is password.
The System Information page displays.
5. Select Security > Access > HTTPS > Certificate Management.
To Next Page
Loading...
Need help?
General
