Configure Switching
144
ProSAFE 10-Gigabit Smart Managed Switch XS728T and XS748T User Manual
The updated configuration is sent to the switch. Configuration changes take effect
immediately.
The following table displays nonconfigurable information about the IGMP snooping querier.
Configure IGMP Snooping Querier for VLANs
You can configure IGMP queriers for use with VLANs on the network.
To create a new VLAN ID for IGMP snooping:
1. Connect your computer to the same network as the switch.
You can use a WiFi or wired connection to connect your computer to the network, or
connect directly to a switch that is off-network using an Ethernet cable.
2. Launch a web browser.
3. In the address field of your web browser, enter the IP address of the switch.
If you do not know the IP address of the switch, see Change the Default IP Address of the
Switch on page 10.
The login window opens.
4. Enter the switch’s password in the Password field.
The default password is password.
The System Information page displays.
5. Select Switching> Multicast > IGMP Snooping Querier > Querier VLAN Configuration.
6. From the VLAN ID menu, select New Entry.
Table 37. IGMP snooping querier information
Field Description
IGMP Version The IGMP protocol version used in periodic IGMP queries.
Only ICMPv2 is supported.
Querier Expiry Interval The interval in seconds after which the last querier information is removed. This
value is calculated as follows: 2 * Query Interval + 5, so by default the value is
2*125+5 = 255.
VLAN IDs Enabled For IGMP
Snooping Querier
The VLANs on which the IGMP snooping querier is enabled. For more
information, see Configure MLD Snooping Querier VLAN Settings on page 151.
To Next Page
Loading...
Need help?
General
