NETGEAR ProSafe XS728T User Manual

Get Started
15
ProSAFE 10-Gigabit Smart Managed Switch XS728T and XS748T User Manual
WARNING:
When you change the IP address of your administrative system, you
lose your connection to the rest of the network. Be sure to write down
your current network address settings before you change them.
7. Click the OK button.
8. Close all other pop-up windows.
 To configure a static address on the switch:
1. Use a straight-through cable to connect the Ethernet port on the administrative system
directly to any port on the switch.
2. Open a web browser on your computer and connect to the management interface.
For more information, see Access the Web Browser–Based Management Interface on
page 16.
3. Change the network settings on the switch to match those of your network.
For more information, see IP Configuration on page 34.
After you change the network settings on the switch, return the network configuration on your
administrative system to the original settings.

NETGEAR ProSafe XS728T Specifications

General

Model	XS728T
Category	Switch
Switching Capacity	560 Gbps
Forwarding Rate	417 Mpps
Ports	24 x 10G SFP+, 4 x 10G Base-T
Management	Web-based, SNMP
Features	ACLs, QoS
Power Supply	Internal 100-240VAC, 50-60Hz
Operating Temperature	0°C to 50°C (32°F to 122°F)
Operating Humidity	90% maximum relative humidity, non-condensing
MAC Address Table Size	32, 000 entries