Initial Setup
14
Outdoor High Power Wireless N Access Point
• IP Address. The IP address of your access point. The default IP address is
192.168.0.100 when it does not get a dynamic IP address. To change it, enter an
unused IP address from the address range used on your LAN, or enable DHCP in a
network with a DHCP server.
• IP Subnet Mask. The access point calculates the subnet mask based on the IP
address that you assign. Otherwise, you can use 255.255.255.0 (the default) as the
subnet mask.
• Default Gateway. The IP address of the gateway for your LAN. For more complex
networks, enter the address of the router for the network segment to which the access
point is connected.
• Primary DNS Server. The IP address for the primary Domain Name Server used by
stations on your LAN.
• Secondary DNS Server.The IP address for the secondary Domain Name Server
used by stations on your LAN.
• Network Integrity Check. Select this check box to enable the access point to
validate that the upstream link is active before allowing wireless associations. If you
set this option you must ensure that your default gateway is configured.
6. Click the Apply button at the bottom of the screen.
Your settings are saved.
If you changed the subnet of the LAN IP address, you are disconnected from the access
point user interface. To reconnect, reconfigure your computer with a static IP address within
the new LAN IP subnet.
Configure the Access Point as a DHCP Server for Wireless
Clients
Your access point comes with a built-in DHCP server for wireless clients only, which can be
especially useful in small networks. You can enable and configure the DHCP server. The
access point will provide TCP/IP configuration for all wireless stations connected to it.
To configure the access point as a DHCP server for wireless clients:
1. Launch a web browser on the computer that is connected to the access point.
2. In the address field of the browser, enter http://192.168.0.100.
A login prompt displays.
3. Enter the user name and password.
The user name is admin and the default password is password.
The General screen displays.
To Next Page
Loading...
Need help?
General
