Troubleshooting and Debugging
59
Outdoor High Power Wireless N Access Point
Troubleshooting with the LEDs
Use the LEDs to verify that the access point is working properly.
All LEDs Are Off
Power is not supplied to the access point.
• Make sure that a power source equipment (PSE) is connected through Ethernet to at
least one PoE port.
• Make sure that the power source equipment (PSE) is powered on.
LAN LED Is Off
A hardware connection problem exists. Do the following:
• Make sure that the cable connectors are securely plugged into the access point and to
the network switch.
• Make sure that the network switch is turned on.
WLAN LED Is Off
The wireless connection does not work. Do the following:
• Make sure the powered device is providing sufficient power to the access point.
• Log in to the access point and verify that the radio or radios are turned on. See Configure
the Basic Wireless Settings on page 15.
• If the WLAN LED remains off, contact NETGEAR technical support.
Cannot Connect to the Access Point to Configure It
Check these items:
• Make sure that the access point is correctly installed, it is powered on, and the LAN LED
is lit.
• Make sure that your computer is using an IP address in the same range as the access
point. The access point default IP address is 192.168.0.100, and the default subnet mask
is 255.255.255.0.
• Quit the browser, clear the cache, delete the cookies, and launch the browser again.
• If you are using the NetBIOS name of the access point to connect, ensure that your
computer and the access point are on the same network segment or that your network
includes a WINS server.
• If your computer is set to obtain an IP address automatically (DHCP client), restart it.
To Next Page
Loading...
Need help?
General
