NETGEAR WND930 User Manual

Hardware Setup
7
Outdoor High Power Wireless N Access Point
Front Panel
Ports, LEDs, and the Reset button are located on the front panel.
LEDs
Reset button
Figure 2. Front panel
Pressing the Reset button restores the factory settings. See Factory Settings on page 62.
LEDs
The LEDs light to indicate wireless access point activity.
Table 1. LEDs
LED Description
Power • Off. Power is off.
• So
lid green. Power is on.
• Amber, then blinking green. A self-test is running or software is being
loaded. During startup, the LED is first steady amber, then goes off, and
then blinks green before turning steady green after about 45 seconds. If
after one minute the LED remains amber or continues to blink green, it
indicates a system fault.
Activity • Off.
No network traffic is detected on the access point.
• Bl
inking green. Network traffic is detected on the access point.
2.4G WLAN • Off. The wireless interface is off.
• So
lid green. The wireless interface is on.
• Blinking green. Wireless activity is detected on the 2.4G band.
5G WLAN • Off.
The wireless interface is off.
• Solid green. The wireless interface is on.
• Bl
inking green. Wireless activity is detected on the 5G band.
Heater • Off.
The heater is off.
• So
lid green. The heater is on.
LAN ports • Off. No
link is detected.
• So
lid green. A link is detected.
• Solid amber.
A 10/100/1000 Mbps speed connection is detected.
• Bl
inking amber. A 10/100/1000 Mpbs speed connection is detected.

NETGEAR WND930 Specifications

General

Brand	NETGEAR
Model	WND930
Category	Wireless Access Point
Language	English