Supplemental Information
62
Outdoor High Power Wireless N Access Point
Factory Settings
You can return the access point to its factory settings. Use the end of a paper clip or a similar
object to press and hold the Reset button on the front of the access point for at least seven
seconds. The access point resets and returns to the factory settings shown in the following
table.
Table 2. Factory default settings
Feature Description
Login for Management and Configuration
LAN IPv4 management address 192.168.0.100
Subnet mask for IPv4 management
address
255.255.255.0
Required static IPv4 address for
management computer
192.168.0.210 and 255.255.255.0
User name (case-sensitive) for login admin
Login password (case-sensitive) for login password
LAN and Management Features
DHCPv4 client Enabled
Syslog Disabled
Spanning Tree Protocol (STP) Disabled
Time zone USA-Pacific
NTP client Enabled
Custom NTP server Disabled
Port speed 10/100/1000
Ethernet MAC address See product label
Radio and Wireless Settings
Operating mode Access point, infrastructure mode
Wireless access point name netgearxxxxxx, where xxxxxx are the last 6 digits of the
wireless access point MAC address
Country and region Varies by region
Wireless communication 2.4 GHz radio enabled
5 GHz radio enabled
Wireless modes 11ng
11na
To Next Page
Loading...
Need help?
General
