Network Settings
27
Outdoor High Power Wireless N Access Point
Spanning Tree Protocol
By default, Spanning Tree Protocol is disabled.
To enable or disable Spanning Tree Protocol:
1. L
aunch a web browser on the computer that is connected to the access point.
2. In the address
field of the browser, enter http://192.168.0.100.
A login prompt displays.
3. Ente
r the user name and password.
The user name is adm
in and the default password is password.
The General screen displays.
4. Select Confi
guration > System > Advanced > General.
5. Select the Spanning Tree Protocol Enable or Disable radio button.
6. T
o require all VLANs to be configured as tagged VLANs, clear the Untagged VLAN check
box.
7. T
o change the untagged VLAN value, enter the new value in the Untagged VLAN field.
8. T
o change the number of management VLANs, enter the new value in the Management
VLAN field.
9. Click the Ap
ply button at the bottom of the screen.
Your settings are saved.
Set Up a Schedule for the Wireless Radios
You can turn the wireless radios on and off according to a schedule.
To set up a wireless on-off schedule:
1. L
aunch a web browser on the computer that is connected to the access point.
2. In the address
field of the browser, enter http://192.168.0.100.
A login prompt displays.
3. Ente
r the user name and password.