New Holland TD60D - Transmission Shafts and Guard Disassembly and Assembly

4
SECTION 23 -- DRIVE LINES -- CHAPTER 1
603.54.471.00 -- 11 -- 2004
Op. 23 101 26
TRANSMISSION SHAFTS AND GUARD
Disassembly -- Assembly
To remove, proceed as follows:
WARNING
Handle all parts with great care.
Do not place hands or fingers between one part and
another.
Always wear the prescribed safety clothing, including
protective glasses, gloves and shoes.
3
1. Disconnect the negative battery lead.
1
25621
4
2. Remove the front, centre and rear screws secur-
ing the front axle prop shaft guard and remove
the guard (1).
3. Remove circlip (2) fig. 5 and move sleeve (1) in
the direction shown by the arrow to disengage it
from the splined shaft of the front axle.
4. To re--fit the transmission shaft and guard, pro-
ceed as follows:
25038
1
WARNING
Use suitable tools to align holes. NEVER USE FIN-
GERS OR HANDS.
5
25040
1 2
-- Fit and secure the transmission shaft in position.
NOTE:
Move t he fr ont splined s leev e (27) against
ret aining ring ( 28). Using a f eeler gauge,
measur e gap bet ween t he sleeve and t he
retaining ring ( 26) and inst all s him (S
5)to
obtain sleeve end play (L) of 1 t o 1.5 mm
(0. 0394 t o 0. 0591 in.) (see Sec t ion 25 page 9).
-- Fit and secure the guard.