11
SECTION 41 − STEERING − CHAPTER 1
603.54.471.00 − 11 − 2004
6
HYDROSTATIC STEERING CONTROL VALVE
Removal−Refitting (Op. 41 204 30)
To remove the hydrostatic steering control valve,
proceed as follows:
1. Disconnect the negative cable (1) from the
battery.
2. Drain the oil from the steering system.
WARNING
Handle all parts with great care. Do not put your
hands or fingers between one part and another.
Wear the recommended safety clothing such as
goggles, gloves and safety boots.
1
25621
7
3. To access the engine the hood must be opened.
TRE0033A
8
4. Disconnect the oil pipes from the hydrostatic
steering control valve unit (1).
TRE0434A
9
5. Remove the steering wheel (1) retaining nut and
remove the steering wheel and hand throtltle
lever.
25758
To Next Page
Loading...
